• NONSLIP - Gritty surface for superior grip.
  
  
• WATER TIGHT - Coated, nonabsorbent surface keeps hands dry and free of messy lube.
  
  
• FLEXIBLE - Soft and pliable material allows full range of hand motion.
  
  
• DURABLE - Quality construction for use in tough conditions.
  
  
• REUSABLE - Rinse, dry, store, and use on the next pull.
  
  
• VERSATILE - Suitable for use with all types of pulling lubricants and cables.
  
  

SureGrip™ Gloves are part of a system of specialty fiber optic lubrication products available from American Polywater. This system can result in significantly longer cable pulls. This system also includes Polywater® F Communications Cable Pulling Lubricant, The FlexLite™ Lubricant Injector Funnel, and the LongShot™ Lubricant Spreader. The maximum length of any pull is dependent on the type of cable, the conduit type and configuration, the lubricant, and the lubrication techniques. We recommend using the Pull-Planner™ 2000 Cable Tension Calculation Software Program coupled with actual in-field tension data for optimal installation planning.

The use of SureGrip™ Gloves and the following basic lubrication and pulling techniques are recommended.

1. Check the conduit system. It should be clean and continuous with no collapsed or displaced sections.
   
   
2. Use the LubeMaster™ Applicator to lubricate the winch rope as it is pulled into the conduit. Unlubricated winch rope start-up tension can often exceed lubricated cable tensions. Lubrication of the winch line eliminates the "burning through" of the rope into the subduct.
   
   
3. Lubricate the entire conduit system. The LongShot™ Lubricant Spreader should be used to spread a metered amount of lubricant ahead of the cable throughout the entire run.
   
   
4. Clean and lubricate the cable with the LubeMaster™ Applicator as the cable is pulled into the conduit.
   
   
5. Pull quickly (preferably 75 ft/minute or more) and avoid stopping. Greater tensions are required to start a cable from rest than are required to keep it in motion (static frictional force is greater than the kinetic).
   
   

1. Practice for the Use of Polywater® Cable Lubricant for the Pulling of Lightguide Cables into Innerduct.
   
2. Practice for the Use of Polywater® Cable Lubricant for the Pulling of Innerduct into Conduit.
   
3. Product flyer on Polywater® F Lubricant.
   
4. Product flyer on the LongShot™ Lubricant Spreader and FlexLite™ Lubricant Injector Funnel.
   
5. Product flyer on the Pull-Planner™ 2000 Cable Tension Calculation Software Program.
   
6. Material safety data sheet (MSDS) on Polywater® F.
   
7. Specification sheet for Polywater® F.
   

Important Notice: The statements and information here are made in good faith based on tests and observations we believe to be reliable. However, the completeness and accuracy of the information is not guaranteed. Before using, the end-user should conduct whatever evaluations are necessary to determine that the product is suitable for the intended use. The user assumes all risks and liability in connection with such use. The statements contained herein are made in lieu of all warranties, express or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose, which warranties are hereby expressly disclaimed. American Polywater's only obligation shall be to replace such quantity of the product proven to be defective. Except for the replacement remedy, American Polywater shall not be liable for any loss, injury or damage, direct or indirect, arising from the use or the failure to properly use these products, regardless of the legal theory asserted. The foregoing may not be altered except by a written agreement by the officers of American Polywater Corporation.